Type: Flexible Power-D-Box® with pcb for 3600/2210/ESX10
特徴
The compact 2U 19inch Power-D-Box® with sockets pre-wired on printed circuit board features aluminium profiled cross members with an anoodized front plate. The panel cutout accommodates up to 30 positions numbered 1 through 30. It is possible to have 6, 12, 18, 24 or 30 prepared slots or to have a redundant distribution with up to 2 x 15 positions.The Power-D-Box® accommodates plug-in type circuit breakers 3600/ 3900 and 2210, solid state remote power controller E-1048-70 and electronic circuit protector ESX10. The required device must be specified in the ordering information as both different installation depth and pcb pin assignments must be allowed for.The devices are plugged into corresponding sockets type 63-P10-Si (6 positions each). These sockets are soldered from the rear onto the pcb, holding a certain pre-wiring.
技術データ
| 取付方法 |
racks |
|---|---|
| サーキットプロテクタタイプ |
thermal-magnetic hydraulic-magnetic electronics |
| 寸法 |
width 19 (482.6 mm) height 2U (88.9 mm) installation depth 205 mm installation depth 250 mm |
| 最大定格電圧 |
DC +65 V AC 250 V |
| 回路数 |
2 x 15 redundant 1 x 30 non-redundant 1-pole protected 2-pole protected 2 x 14 redundant |
| サーキットプロテクタ・ブレーカ型式 |
2210 1-pole 2210 2-pole 3600/3900 ESS20 |
| 供給 |
redundant non-redundant |
| 端子形状(供給側) |
Screw terminals Terminal studs (for cable lugs) M6 |
| 最大負荷電流 |
16 |
| 端子形状 |
Screw terminals 2.5 mm² |
| シグナリング |
Make contacts connected in series Break contacts connected in parallel |
| 端子形状(補助接点) |
2.5 mm² |
| 操作温度範囲 |
0 … +50 °C |
| Further technical data |
are available upon request |
アクセサリー
| ご注文型式 | 特徴 | |
|---|---|---|
| X 222 066 01 | ジャンパ | |
| Y 308 563 01 | ブランクモジュール 3600/3900; 2210用 | |
| Y 308 563 41 | ブランクモジュール ESS20, ESX10 | |
| Y 308 602 01 | 取り外しツール(ESS20/ESX10用) |
用途
- Power-D-Box-Systems
- オートメーションシステム
- パワーエンジニアリング DC24V
- 化学、オイル・ガス工場
- 通信機器、データセンタ